What liquid rubber equipment is needed?

In order for the waterproofing layer of liquid rubber to be seamless and of high quality, special equipment is needed. The equipment sold in our country varies by country and manufacturer. Installations can be two-channel, which consist of two pumps. They pump mastic components from special containers and are transferred under pressure through hoses to the sprayer. There are special nozzles on the sprayer, passing through which the liquid turns into aerosol droplets. Two streams of mastic are mixed in the air and begin to turn into rubber. Installations can work either using a mechanical or gasoline drive. They differ in the power of the pumps. The price of this equipment depends on all these factors.

Imported plant models are several times more expensive than domestic ones. Our Russian UZHK-2 installations differ from foreign brothers in the type of drive. The Russian installation uses an electric drive. But for the operation of the installation, it is not necessary to have a stationary power supply. A generator is built into the equipment, which can be pre-energized. Also, the generator can be used in the operation of an air compressor, with which it will be possible to prepare the surface for liquid rubber.

Gasoline imported analogues pollute the environment with their exhausts; it is also unsafe to use it indoors. And fire safety rules when working near gasoline equipment are also very important. What our Russian builders do not always observe.

Russian equipment is equipped with sensors for regulating performance and can work on any raw material, which again can not be said about Western counterparts.

Another advantage of the domestic installation is a pump for pumping the solution. It is made of stainless steel, which only increases the life of the equipment. Failed pumps can be easily replaced with others without disassembling the entire installation.

And since we do not cooperate with any online stores, we cannot recommend a specific seller of equipment to you. In general, it is better to purchase equipment directly from the manufacturer.